Clarke FOCUS S28 Manual Del Operador página 24

ENGLISH EN
B
Figure #21
Figure #22
Figure #23
-24- Form No. 70851A
MAINTENANCE
Do These Procedures When You End Your Work
1. Drain the solution tank (Figure #21, item A) and the recovery tank
(Figure #21, item B). To drain the tanks , follow this procedure:
a.
b.
A
c.
d.
2. Flush the tanks. To fl ush the tanks, put clean water in the tank
through the opening on top of the tank.
3. If a tank or drain hose has an obstruction, use a high pressure water
hose to fl ush the tank or hose. Put the water hose into the drain
hose.
4. Leave the tanks and the drain valves open to dry in the air.
5. Check the squeegee blade. Use a cloth to clean the squeegee
blade. If the squeegee blade is damaged or worn, turn or replace
the blade.
6. Check and clean the recovery lid gasket. Use a mild cleaning
solution and rinse the parts in clean water.
Check the batteries and add distilled water as needed. The correct level
is within 1/4 inch of the bottom of the tube in each cell.
Tap water may contain contaminants that will damage batteries.
Batteries must be re-fi lled with distilled water only.
Lead acid batteries generate gases which can cause an explosion.
NO SMOKING. Always wear eye protection and protective
clothing when working near batteries.
Use a clean cloth and wipe the surface of the machine.
Charge the batteries. See the instruction in the section of this book
called "How To Charge The Batteries".
Clarke
®
Operator's Manual (EN) - FOCUS S28/L28/S33/L33/S38/L38 WB
Turn the key switch "OFF".
Remove the drain hose from the back of the machine.
Put the end of the hose over a drain or bucket.
Recovery Tank:
Turn the valve housing to the left (see fi gure #22). To open the
valve completely, turn the housing fully to the left and pull the
housing off of the valve.
Solution Tank:
When hose is lowered below water level, the water will drain
(see fi gure 23).
CAUTION!
WARNING!