Changing The Oven Light; Cleaning The Exterior; Stainless Steel Surfaces - LG LWD3063ST Manual De Propietario

CHANGING THE OVEN LIGHT

The oven light is a standard 10-watt halogen bulb for
ovens.
Replacing Lamp on Side Wall
• Make sure oven and bulb are cool.
1. Unplug oven or disconnect power.
2. Remove oven racks.
3. Slide a flat blade screwdriver between the
housing and the glass light cover.
4. Support the glass light cover with two fingers to
prevent the cover from falling to the bottom of
the oven.
5. Gently twist the screwdriver blade to loosen the
glass light cover.
6. Remove bulb from socket.
7. Replace bulb, replace light cover by snapping
back into place.
8. Plug in oven or reconnect power.
Glass Light Cover
Flat blade screwdriver
Replacing Lamp on Top Wall
• Make sure oven and bulb are cool.
1. Unplug oven or disconnect power.
2. Remove oven racks.
3. Slide a flat blade screwdriver between the
housing and the glass light cover.
4. Support the glass light cover with two fingers to
prevent the cover from falling to the bottom of the
oven.
5. Gently twist the screwdriver blade to loosen the
glass light cover.
6. Remove bulb from socket.
7. Replace bulb, replace light cover by snapping
back into place and push the clip to hold the glass
light cover tightly.
8. Plug in oven or reconnect power.
Flat Blade screwdriver
• Before replacing the oven light bulb,
Housing
• Make sure oven and bulb are cool.
• Wear gloves while changing the oven light.

CLEANING THE EXTERIOR

Painted Parts and Trim
For general cleaning, use a cloth with hot and soapy
water. For more difficult soils and built-up grease,
apply a liquid detergent directly onto the soil. Leave
on soil for 30 to 60 minutes. Rinse with a damp cloth
and dry. DO NOT use abrasive cleaners on any of
these materials; they can scratch the parts and trim.

Stainless Steel Surfaces

Do not use a steel-wool pad, it will scratch the surface.
1. Place a small amount of Stainless Steel Appliance
2. Clean a small area, rubbing with the grain of the
Glass Light Cover
WARNING
DISCONNECT the electrical power to the
oven at the main fuse or circuit breaker
panel.
– Failure to do so can result in severe personal
injury, death, or electrical shock.
Glass fragments from broken bulbs can cause
risk of injury.
Cleaner or polish on a damp cloth or damp paper
towel.
stainless steel if applicable.
35
MAINTENANCE
Flat Blade
Clip
Screwdriver
Bulb