Sioux Tools TC50A Serie Instrucciones página 30

— MAIN MENU —
TIME/DATE
05-23-03 11:50
UP/SET DWN/EXIT
— SET TIME/DATE —
MONTH: 05
IMPOSTAZIONE DYNAMIC
— CAL TRANSDUCER —
UNITS: NM
— CAL TRANSDUCER —
MAX: XXX NM
— CAL TRANSDUCER —
CAL COMPLETE
SETUP PSET 01
TGTQ: 000 NM
— LEARN TGTQ —
RUN TOOL
— LEARN REHIT —
RUN TOOL
— LEARN PREVAIL —
RUN TOOL
— LEARN FREERUN —
— TEST SETTINGS —
000.0 CYCLE:
TQ: XXX.X PSET 01
COUNT: 00/XX OK
SEQUENZA DI PROGRAMMAZIONE
ALGORITMO PER GLI UTENSILI AD ACCOPPIAMENTO DIRETTO
— MAIN MENU —
TIME/DATE
05-23-03 11:50P
UP/SET DWN/EXIT
— SET TIME/DATE —
MONTH: 05
SET PARAMETER 01
TGTQ: 000.0
— LEARN FREERUN —
RUN TOOL
— LEARN PREVAIL —
RUN TOOL
— LEARN REHIT —
RUN TOOL
TgTq: XXX PSET 01
COUNT: 00/XX
SEQUENZA DI PROGRAMMAZIONE
ALGORITMO PER GLI UTENSILI A IMPULSI/IMPACT
— MAIN MENU —
PARAMETER SETUP
PARAMETER SETUP
UP/PRGM DWN/CLR
PARAMETER SETUP
UP/DYN DWN/MAN
SETUP PARAMETER
PSET # 01
SET PARAMETER 01
COUNT: XX
RUN TOOL
— DYNAMIC LEARN —
RUN TOOL
— JOINT TYPE —
TYPE: MANUAL
— MAIN MENU —
PARAMETER SETUP
PARAMETER SETUP
UP/PRGM DWN/CLR
SETUP PARAMETER
PSET # 01
SET PARAMETER 01
COUNT: XX
— CHECK FLOW —
OK
FLOW LEVEL LOW
— MAIN MENU —
CYCLE COUNT
CYCLE COUNTER
UP/SET
CYCLE COUNTER
COUNT: 500,000
— CAL TRANSDUCER —
USE TRANSDUCER?
UP/YES DWN/NO
—TORQUE ADJUST—
TQ:000.0
SET PARAMETER 01
TGTQ: 000.0
— JOINT TYPE —
TYPE: SOFT
— TEST SETTINGS —
000.0 CYCLE:
— MAIN MENU —
VOM: 048-052
CYCLE COUNTER
— CAL TRANSDUCER —
USE TRANSDUCER?
UP/YES DWN/NO
— TORQUE ADJUST —
TQ:000.0
— CHECK FLOW —
FLOW LEVEL HI
— CHECK FLOW —
FLOW LEVEL GOOD
30
10039.7.16
DWN/CLR
IMPOSTAZIONE
MANUAL
— CAL TRANSDUCER —
MAX: XXX NM
UNITS: NM
SIG:075
— LEARN REHIT —
RUN TOOL
— LEARN PREVAIL —
RUN TOOL
— LEARN FREERUN —
RUN TOOL
— JOINT TYPE —
TYPE: HARD
— JOINT TYPE —
TYPE: MEDIUM
TgTq: XXX PSET 01
COUNT: 00/XX OK
#10041.7.16
— MAIN MENU —
CYCLE COUNT
CYCLE COUNTER
UP/SET DWN/CLR
COUNT: 500,000
— CAL TRANSDUCER —
MAX: XXX NM
UNITS: NM
SIG:075
— CHECK FLOW —
RUN FREESPEED