Battery Installation / Replacement; On / Off Switching - METRICA 120zoom Manual Del Usuario

SAFETY
Before using the device, read the safety instructions and the user
manual carefully. Improper use of the device, which does not con-
form to the instructions in this manual, may damage the device,
affect the measurement results, or physically damage the user. It is
not allowed to disassemble or repair the device. Any modification
or modification of the laser power is prohibited. Keep out of reach of
children and unqualified persons. It is strictly forbidden to aim the
laser at the eyes or other body parts, it is forbidden to aim the laser
at a reflective surface. Due to the interference of electromagnetic
radiation with other instruments, do not use the unit in aircraft or
near medical equipment or in flammable / explosive environments.
Observe local regulations when disposing of batteries or instru-
ments. If you have questions about the device, contact your local
dealer. Professional quality brings a good reputation

BATTERY INSTALLATION / REPLACEMENT

Open the battery compartment on the back of the device and
insert the batteries with the correct polarity. Close the lid.
Use only 2 rechargeable 1.2A 2400AhAANi-Mh batteries. Never
use non-rechargeable batteries: there is a risk of explo-
sion during charging. A charging cable is included
the device is not used for a long time, remove the batteries from
the battery compartment to prevent corrosion of the device body.

ON / OFF SWITCHING

To turn on the device, press for three seconds
20
and the laser will turn on simultaneously and ready are to me-
asured.
To turn off the device: press
device is inactive for 150 seconds, it will automatically switch off
(the user can set this duration in the menu, see Menu / Settings).
ADJUSTMENT OF THE MEASURING UNIT
Briefly press
Press ,
Press to enter the function.
Press or
press , the frame turns green. The user can select the unit
by pressing
the change by pressing
THERE ARE 8 UNITS TO BE SELECTED
lenght
. If
, the device
for at least 3 seconds. If the
to enter the setup menu.
, , to choose the setting function
to move the red frame on the element
or , press , the frame turns red and saves
.
surface
.
,
volume