Publicidad
Idiomas disponibles
Idiomas disponibles
REFERENCE POINT
Press
to change the starting point. There are four referen-
ce points: on the front part, on the tripod mounting thread, at the
bottom of the device and on the tip of the end piece:
SIMPLE OR SINGLE MEASUREMENT
Briefly press
while in measuring mode, the laser lights up;
point at the object to be measured.
Press
again for a single distance measurement: the result is
displayed on the screen.
To clear the result on the screen, press
The last 3 measurements are displayed in the auxiliary display area.
To clear the result on the screen, press
CONTINUOUS MEASUREMENT
To activate this mode, keep the
shows the results of the minimum and maximum measure-
key pressed: the display
ments. The screen simultaneously displays the current measure-
ment, the results of the minimum and maximum measurements
and their difference ∆.
To exit the continuous measuring mode, press briefly
clear the result on the screen, press
AREA MEASUREMENT
Press once
, the symbol
plete the following steps based on the suggestions on the screen:
- Press
to measure the first side (length)
- Press
to measure the second side (height)
The surface is calculated automatically. Perimeter and surfa-
ce results are displayed on the screen.
- Briefly press
to clear the results and be ready for
another measurement
- Press long
to save the result
VOLUME MEASUREMENT
Press
twice, the display shows
Complete the following steps based on the suggestions on the
screen:
- Press
to measure the first side (length)
- Press
to measure the second side (depth)
- Press
to measure the third side (height). The volume is
calculated automatically.
- Press
once to display the area of the base.
. To
.
appears on the screen. Com-
.
21
Publicidad
