Setting Up; Precautions; Unpacking The Set; Wire Feeder Slinging - Air Liquide DV YARD Manual Del Usuario

2 - SETTING UP

2.1 - PRECAUTIONS

Ensure to not pinch the cables and gas hoses
■
Ensure correct installation of power connections.
■
Do not leave liquid or hot material to be in contact with the cables.
■
The stability of the system is supported up to angles of 10°.
■
The connection of the wire feeder unit is to made while the power
■
source is off.

2.2 - UNPACKING THE SET

Remove the various items from their packaging.

2.3 - WIRE FEEDER SLINGING

For slinging the wire feeder, you must use the handle.

2.4 - WIRE FEED UNIT CONNECTION

1. Place the ¼ female turn on power cable, then connect cable to the
DV YARD terminal on the front.
2. Connect the other end of cable to + terminal of power source.
3. Connect power source - plug to the workpiece.
4. Connect the DV YARD earth clamp to the workpiece.
5. Connect the MIG torch on DV YARD
6. Place the gas hose on the regulator of gas installation (use specified
gas for MIG-MAG welding).
7. Adjust the gas flow and bleed the circuit ..
POWER SOURCE
The DV YARD has a microprocessor based system that allows it to
automatically recognize whether the power source works in Constant-
Current (CC) or Constant-Voltage (CV) and to adapt accordingly without
any selector.
Adjust the power (voltage) on power source and the wire speed on DV
YARD according to the advice placed on DV YARD door. Close the wire
feed unit door and press the torch trigger. Let the wire appears at the torch
end, on the contact tip output.
Your installation is ready to weld.
SETTING UP
5 - EN
EN