Cequent Performance Products 65070 Instrucciones De Instalación página 5

1. Remove 2 M12 bolts, one from each end of the front bumper beam, remove
end caps and return to customer. For ease of access to the inside of the vehicle
frame, remove skid shield (if present) by removing 4 M8 bolts. Remove plastic
covers from inside and outside of frame rails both sides at bolt locations.
3. Where the end cap was removed in step 1, place the 1.50" carriage bolt
and spacer (item 2) into the existing hole in the bumper beam.
©2016 Cequent™ Performance Products, Inc. -
Printed in Mexico
2. Place the 4.00" bolt into the spacer (Item 4) and into the existing holes from
the inside of the frame.
4. Hang the side brackets from the 4.00" bolts installed in step 2 on the
outside of the frame rails and place a conical washer(teeth side toward hitch)
and hex nut on the bolt finger tight.
Sheet 5 of 18 65070NP 2-8-16 Rev. C