Manual Cleaning - Bissell SPOTBOT PET 33N8 Serie Guía De Uso

Operations
To begin cleaning
1. Place the filled clean water/solution tank onto
the unit.
2. Plug your SpotBot in. The power light
will illuminate, indicating your SpotBot
is ready to go.
Automated cleaning
1. Place the unit directly over the spot or stain,
making sure the stain is in the center of the
cleaning area.
2. Select which cleaning cycle (surface stain or
set-in stain) you would like to use. SpotBot will
begin spraying, brushing and suctioning the
soiled area, in a pre-programmed cycle. Both
cycles have been tested and proven to deliver
superior cleaning results, taking the guesswork
and effort out of cleaning for you.
3. When the cleaning cycle you have selected is
complete, the Finish light will illuminate and the
machine will sound a series of "beeps". Press
the STOP button to turn the machine off. The
machine will not beep when turned off.
4. Pick up the unit and check the area that was
cleaned.
5. If you use BISSELL Boost Oxy, it will continue
to work for the next six to eight hours, cleaning
your spots and stains all the way to the backing
of the carpet.

Manual cleaning

1. Remove the hose from the unit by
depressing the release button.
2a. Remove the Tough Stain Brush from the back
of the unit.
2b. Attach the Tough Stain Brush onto the grip
of the hose.
3. Select the hose button on the control panel to
start the SpotBot.
NOTE: In manual mode, the SpotBot will not
turn on until the hose is disconnected from the
hose connector. If it is not removed within 30
seconds of pushing the hose button, the unit
will shut off.
4. Begin cleaning by holding the tool no more
than six inches above the soiled surface. Depress
the spray trigger for about 5 seconds to apply
the cleaning solution to the soiled area. Release
the trigger. Be careful not to overwet.
5. Using the brush on the tool, gently scrub the
soiled area until it appears to be clean.
Tips
» One of the effective stain removing ingredients
in Boost Oxy is Hydrogen Peroxide. Certain
people may be affected by the product when it
comes into contact with their skin; it may turn
the skin white and/or cause tingling. Washing
your hands after use and applying hand lotion
will remove any possible white discoloration.
» Check upholstery stuffing before cleaning.
Colored stuffing may bleed through the fabric
when it becomes wet. Check manufacturer's
tag before cleaning.
1.
2a.
3.
www.BISSELL.com
2b.
7