Auto-Following; Handle Positions; Apply Detergent - Generac 49-ST-CSA El Manual Del Propietario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Power Washer Shut Down
Fluid Injection. This machine produces
high-pressure fluid streams that can pierce
skin. Fluid injection could result in death or
serious injury.
IMPORTANT: Spray gun traps high-pressure
water, even when engine is stopped and water
is disconnected. Always point spray gun in
safe direction, and squeeze spray gun trigger
to release high-pressure. Engage trigger lock
when not in use.
1. Release spray gun trigger.
2. Turn engine switch OFF.
3. Squeeze spray gun trigger and release
high-pressure water.
4. Engage trigger lock.
5. Turn water supply OFF.
NOTE: Keep high-pressure hose connected
to pump and spray gun while system is pres-
surized.

Auto-Following

See
Figure
3-7. Release front wheel brake by
depressing the OFF side of the wheel brake
foot lever (A).
A
Figure 3-7. Auto Follow
Unit will now "follow" the user by pulling on the
high pressure hose line.
To lock unit from moving, engage the front
wheel brake by depressing the ON side of the
wheel brake foot lever.

Handle Positions

See
Figure
3-8. Pull ring (A) to unlock handle
pin. Move handle to desired position and con-
firm handle pin locks into place.
• Storage Position (1)
• In Use Position (2)
• Tight Maneuver Position (3)
Owner's Manual for Power Washer
WARNING
(000106b)
010773
2
3
A
Figure 3-8. Handle Positions

Apply Detergent

Fluid Injection. This machine produces
high-pressure fluid streams that can pierce
skin. Fluid injection could result in death or
serious injury.
Personal injury. Risk of fluid injection. Do not aim
spray gun at people, animals, electrical devices, or
fragile items. Keep out of reach of children. Failure to
do so could cause death or serious injury.
NOTE: DO NOT use caustic liquid with power
washer. Use ONLY power washer safe deter-
gents. Follow manufacturer instructions on
detergent label.
Apply detergent as follows:
1. Prepare detergent solution as required by
job.
2. See
Figure
3-9. Pull ring to release and
lower bucket holder until it locks in place.
Figure 3-9. Bucket Holder Release
3. Place detergent bucket onto bucket holder
and secure with bungee cord.
4. Feed
siphoning
bucket.
5. Make sure siphoning tube remains fully
submerged into the detergent.
6. Verify black detergent nozzle is installed.
NOTE: Detergent cannot be applied with high-
pressure nozzle (Yellow, White, Green or
Red). Only use black nozzle with detergent.
1
WARNING
(000106b)
WARNING
A
010772
tube
into
detergent
011151
(000117c)
9

Publicidad

Tabla de contenido
loading

Tabla de contenido