Check Pump Oil Level; Engine Maintenance; Engine Oil Recommendations; Inspect Engine Oil Level - Generac 49-ST-CSA El Manual Del Propietario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6. Clean up any spilled oil.
7. Properly dispose of oil in accordance with
all applicable regulations.
B
A
Figure 4-6. Drain/Fill Oil

Check Pump Oil Level

3300 and 3600 PSI Units
1. Place power washer on a flat, level
surface.
2. See
Figure
4-7. Clean area around oil fill
and remove vented cap/dipstick (B).
B
Figure 4-7. Check Pump Oil
3. See
Figure
4-8. Check to confirm oil level
is between the "L" and "H" on the dipstick.
If oil is required, see
DO NOT OVERFILL.
4. Install oil dipstick and hand-tighten.
5. Clean up any spilled oil.
Figure 4-8. Pump Oil Dipstick
4000 and 4200 PSI Units
1. Place power washer on a flat, level
surface.
Owner's Manual for Power Washer
C
010771
A
009079
Change Pump
H
L
000268
2. See
Figure
bead in sight glass window (A).

Engine Maintenance

Engine Oil Recommendations

To maintain the product warranty, the engine
oil should be serviced in accordance with the
recommendations of this manual. For your
convenience, maintenance kits designed and
intended for use on this product are available
from the manufacturer that include engine oil,
oil filter, air filter, spark plug(s), a shop towel
and funnel. These kits can be obtained from
an Independent Authorized Service Dealer
(IASD).
Climate
determines
viscosity. See chart to select correct viscosity.
5W-30
Figure 4-9. Oil Viscosity
* Below 50°F (10°C) use of SAE 30 will result
in hard start.
** Above 80°F (27°C) use of 10W30 may
cause increased oil consumption. Inspect
oil level more frequently.

Inspect Engine Oil Level

Inspect engine oil level prior to each use, or
every 8 hours of operation.
1. Place power washer on a flat, level
surface.
2. Clean area around oil fill.
3. See
Figure
dipstick and wipe dipstick clean.
Oil.
Figure 4-10. Engine Oil Fill
For 3300, 3600 and 4200 PSI Units
4. See
Figure
filler neck. Oil level is checked with
dipstick fully inserted.
Maintenance and Troubleshooting
4-6. Confirm oil level of red
proper
engine
SAE 30*
10W-30**
4-10. Remove oil fill cap/
4-11. Thread dipstick into oil
oil
000130
000115
13

Publicidad

Tabla de contenido
loading

Tabla de contenido