Nozzles - Generac 49-ST-CSA El Manual Del Propietario

General Information and Setup
Figure 2-11. Spray Gun (typical)
2. Turn ON the water, and squeeze the
trigger to purge the pump system of air.
3. Verify spray gun is OFF with lock engaged
before starting power washer.

Nozzles

1. Select correct nozzle for task.
2. See Figure 2-12. Pull back quick–connect
collar and install nozzle.
3. Release quick-connect collar to secure
nozzle.
4. Verify nozzle is locked in place.
Figure 2-12. Insert Nozzle
Blast Pressure Nozzle (Red)
MAXIMUM - Higher pressure and lower flow
for stubborn or hard to reach surface such as
second story surfaces, paint removal, oil
stains, rust removal
substances (tar, gum, grease, wax, etc.).
Strip Pressure Nozzle (Yellow)
MEDIUM - Higher pressure and medium flow
for removing stains on hard porous surfaces
such as concrete driveways, garage floors
and brick patios.
6
000123
000125
or other stubborn
001396
001397
Clean Pressure Nozzle (Green)
GENERAL - Medium pressure and medium
flow for most all purpose cleaning such as
home siding, brick patios, wood decks,
driveways and sidewalks, garage floors, etc.
Wash Pressure Nozzle (White)
DELICATE - Lower pressure and higher flow
for gentle cleaning of cars/trucks, boats, RV's,
patio furniture, lawn equipment, etc.
Detergent Nozzle (Black)
DETERGENT ONLY (BLACK), Only use
power washer safe detergents/soaps to help
break down stubborn dirt and grime on a
variety of surfaces.
Owner's Manual for Power Washer
001398
001399
001400