Water Supply; Connect Water Supply; Connect High-Pressure Hose And Lance; Spray Gun - Generac 49-ST-CSA El Manual Del Propietario

Water Supply

NOTE: DO NOT run unit without sufficient
water supply. Failure to follow water supply
requirements will void unit warranty.
Water supply must
requirements:
• DO NOT siphon standing water for the
water supply.
• Water temperature must be less than
100°F (38ºC).
• Water supply hose length must not exceed
50 ft (15.2 m).
• Water must be greater than 3.8 gallons per
minute (17.3 liters per minute) and no less
than 30 psi (206.8 kPa).
• DO NOT use a one-way valve, vacuum
breaker, or check valve in any part of the
water supply.

Connect Water Supply

1. Remove and discard shipping cap from
the pump water inlet.
2. Run water supply for 30 seconds prior to
connection to eliminate debris.
3. See Figure 2-7. Inspect inlet screen for
debris (A). Clean screen or replace as
necessary. DO NOT run power washer if
inlet screen is damaged or missing.
4. See Figure 2-7. Connect water supply
hose to pump water inlet and hand-
tighten.
A
Figure 2-7. Inspect Inlet Screen and
Connect Water Supply Hose
.
Connect High-Pressure Hose
and Lance
1. See Figure 2-8. Connect lance to spray
gun and hand-tighten.
Owner's Manual for Power Washer
meet the following
009080
General Information and Setup
Figure 2-8. Connect Lance
2. Place spray gun and nozzle lance into
spray gun holder.
3. See Figure 2-9. Connect high-pressure
hose to quick connect fitting on front panel
of unit.
Figure 2-9. Connect High-Pressure Hose
to Quick Connect Fitting
4. See Figure 2-10. Connect high-pressure
hose to base of spray gun.
Figure 2-10. Connect High-Pressure Hose
to Spray Gun

Spray Gun

Become familiar with spray gun trigger and
locking system prior to use.
1. See Figure 2-11. With unit OFF, hold spray
gun and squeeze trigger to learn how
trigger mechanism and locking system can
be activated and deactivated.
009064
011000
009081
5