Section 3 Operation; Operation And Use Questions; Before Starting Engine; Prepare Power Washer For Use - Generac 49-ST-CSA El Manual Del Propietario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Section 3 Operation

Operation and Use Questions

Call Generac Customer Service at 1-888-
GENERAC (1-888-436-3722) with questions
or
concerns
about
maintenance.

Before Starting Engine

1. Verify engine oil level is correct.
2. Verify fuel level is correct.
3. Verify all fittings and couplers are properly
secured.
4. Verify sufficient water supply is properly
connected.
5. Verify unit is secure on level ground, with
proper clearance and is in a well ventilated
area.

Prepare Power Washer for Use

1. Place unit on level ground, within the spec-
ified clearance required.
2. Connect appropriate water supply.
Power Washer Placement for Use
Asphyxiation. Running engines produce carbon
monoxide, a colorless, odorless, poisonous
gas. Carbon monoxide, if not avoided, will
result in death or serious injury.
WARNING
Risk of Fire. Hot surfaces could ignite
combustibles, resulting in fire. Fire could
result in death or serious injury.
WARNING
Hot Surfaces. When operating machine, do not
touch hot surfaces. Keep machine away from
combustibles during use. Hot surfaces could
result in severe burns or fire.
It is a violation of California Public Resource
Code, Section 4442, to use or operate the
engine on any forest-covered, brush-covered,
or grass-covered land unless the exhaust sys-
tem is equipped with a spark arrester, as
defined in Section 4442, maintained in effec-
tive working order. Other states or federal
jurisdictions may have similar laws.
Only operate power washer outdoors in a well
ventilated area. Never operate power washer
indoors, or in a confined space. Be aware of
building openings and ventilation systems
where exhaust may enter during use.
• Verify power washer is placed on level
ground to avoid tipping during operation.
Owner's Manual for Power Washer
unit
operation
DANGER
• Only use the unit outdoors. Verify exhaust
gas does not enter a confined area through
windows, doors, ventilation intakes.
• See
and
clearance on all sides of power washer
including overhead from dwellings and
combustibles, when in use.
Figure 3-1. Five Feet of Minimum Clearance
Power Washer Start-Up
NOTE: DO NOT run power washer without a
sufficient water supply turned ON. Damage to
equipment resulting from failure to follow this
instruction will void warranty.
1. Connect a sufficient water supply.
2. Move fuel valve (B) to ON.
3. Move choke lever (A) to CLOSE.
(000103)
(000110)
(000108)
NOTE: For warm engine, verify choke lever is
in OPEN position.
4. See Figure 3-3. Move throttle lever to the
HIGH position.
Figure
3-1. Keep at least 5 ft (1.5 m) of
Figure 3-2. Fuel Valve and Choke
000271
A
B
000127
7

Publicidad

Tabla de contenido
loading

Tabla de contenido