Safety Information - EAS ELECTRIC EASCOMPACT Instrucción De Montaje

Safety information

Avvertenze per la sicurezza
Instructions de sécurité
Advertencias de seguridad
Indicações de segurança
Safety precautions: Before commencing mounting work on
roofs, it must be ensured in all cases that the non- personal
fall protection and fall-arrest systems required by DIN 18338
(Roof Covering and Roof Sealing Works) and DIN 18451
(Scaffolding Works) are in place. See also Builders' Protec-
tion Ordinance [Bauarbeiterschutzverordnung], Federal Law
regulations must be observed!
If non-personal fall protection or fall-arrest systems cannot
be installed for technical reasons, all personnel must be
secured by means of suitable safety harnesses!
Only use safety harnesses (safety belts, lanyards and straps,
by authorized testing bodies.
If non-personal fall protection or fall-arrest systems are
not provided, working without the use of suitable safety
harnesses may lead to falls from heights and therefore cause
serious or lethal injuries!
Ladders not properly secured against sinking in, sliding or
falling over may lead to dangerous falls!
Whenever you are near live overhead electric cables where
contact is possible, only work if:
it is ensured that they are voltage-free and this is secu-
–
red for the duration of work.
the live parts are secured by covering them or cordo-
–
ning them off.
the prescribed safety distances are maintained.
–
Voltage radius:
1 m ................voltages up to 1000V
3 m ................voltages from 1000V to 11000V
4 m ................voltages from 11000V to 22000V
5 m ................voltages from 22000V to 38000V
> 5 m in case of unknown voltages
4
30°
Never use damaged ladders (e.g., wooden ladders with split
runners or rungs, or bent or buckled metal ladders). Never
try to repair broken runners, rungs or steps on wooden
ladders!
Ensure that ladders are put up safely. Observe the correct
leaning angle (68° - 75°). Prevent ladders from sliding, falling
over or sinking into the ground (e.g. using wider feet, feet
suited to the ground or hooking devices).
Only lean ladders against secure points. Secure ladders in
Contact with live electric overhead cables can be lethal.
Wear protective goggles when drilling and handling collec-
tors!
Wear safety shoes when carrying out installation work!
Wear cut-proof safety gloves when mounting
collectors!
Wear a helmet when carrying out installation work!
EN EN
20°
5-45°
V.1