How To Operate Your Ceiling Fan - Fanimation The Jennix FPD7943 Serie Manual Del Propietário

1. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box (Figure 1).
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
NOTE: Receiver in controllers system features an
automatic learning function. There are no frequency
switches on the receiver unit. The receiver will
automatically scan the frequency from the hand held
control if an changes are made. the frequency settings
should be changed only in the case of interference or
if multiple ceiling fans with the same type of control
system are installed in the same structure.
2. To make fan operational, install 23A/12V battery
(included) in hand-held remote transmitter, with fan
power off, arrange code switches to desired code setting.
Then follow the remote code setting process. (If not used
for long periods of time, remove battery to prevent damage
to transmitter). Store the remote away from excessive heat
or humidly (Figure 2).
3. Remote Control Setting and Speed (RPM)
Setting Process : (Figure 3)
1. After installing the unit and restoring power to
your fan, press and hold the "SET" button 1~5
seconds. You must press the "SET" button
within 60 seconds of restoring power to the fan.
2.The fan will start to run and begin the control
setting process. The fan will run in both
directions for a total of approximately 5 minutes.
3. When the fan stops after approximately 5
minutes the control and speed setting process
is complete.
The fan is now ready for normal use.
NOTE: If you want to change the blades: turn
4. The remote buttons instruct as below:
Fan speed:
I = minimum speed
III = medium low speed
V = medium high speed
Button:
This button turns the fan off.
Reverse button:
This button is to control fan direction.
Light button:
The button is to control light, Infinite light levels
are available by holding the light on/off button
(Figure 4).

How to Operate Your Ceiling Fan

WARNING
II = low speed
IV = medium speed
VI = high speed
12
MAIN FUSE BOX
Figure 1
Figure 2
Figure 3
Figure 4