How To Wire Your Ceiling Fan - Fanimation The Jennix FPD7943 Serie Manual Del Propietário

How to Hang Your Ceiling Fan (continued)
4. Carefully lift the fan and seat the downrod/hanger ball
assembly on the hanger bracket that was just attached to
the outlet box. Be sure the groove in the ball is lined up
with tab on the hanger bracket (Figure 4)
WARNING
Failure to seat tab in groove could cause damage to
electrical wires and possible shock or re hazard.
WARNING
To avoid possible shock, do not pinch wires between
the hanger ball assembly and the hanger bracket.
5. Attach the safety cable to ceiling support cable. Slide
cable clamp onto safety cable (from fan). Place the end
of cable through the loop of ceiling support cable. Pull as
much cable through loop as possible. Feed end of cable
into clamp hole and firmly tighten screw (Figure 4).
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before hanging
(Figure 1).
NOTE: If you are not sure if the outlet box is
grounded, contact a licensed electrician for advice, as
it must be grounded for safe operation.
1. Connect the green grounding lead from the
downrod/hanger ball assembly and the green
grounding lead from the hanger bracket to the supply
grounding conductor (this may be a bare wire or wire
with green colored insulation). Securely connect wires
with wire connectors. Securely connect the white fan
motor wire to the white supply (neutral) wire using
wire connector. Securely connect the black fan motor
wire to the black supply wire using wire connector
(Figure 2).
NOTE: If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan installed
by a licensed electrician.
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors except for the ground wire. Do not
operate fan until the blades are in place. Noise and
motor damage could result.

How to Wire Your Ceiling Fan

WARNING
WARNING
TAB
NOTE: SUPPLY WIRES AND FAN
WIRES OMITTED FOR CLARITY
HARDWARE USED:
CEILING SUPPORT
CABLE CLAMP
W/SCREW
Green Wire
from Supply
(Ground)
Green Wire
from Hanger
Bracket (Ground)
Green Wire
from Hanger
Ball (Ground)
HARDWARE USED:
WIRE
CONNECTORS
8
ATTACH SAFETY
CABLE TO CEILING
SUPPORT CABLE
DOWNROD/HANGER
BALL ASSEMBLY
Figure 4
X 1
MAIN FUSE BOX
Figure 1
White Wire
from Supply
Listed
Outlet Box
Household
White Wire
Supply
from Fan
Black Wire
from Supply
Black Wire
from Fan
Figure 2
x 3