Tools Needed For Assembly; Unpacking Instructions - Fanimation ODYN MAD8152 Serie Manual Del Usuario

This manual is designed to make it as easy as possible for you to assemble,
install, operate and maintain your ceiling fan

Tools Needed for Assembly

(Not Included)
ne hillips head screwdriver
One stepladder
!
Before assembling your ceiling fan, refer to section
on proper method of wiring your fan (page 10). If you
feel you do not have enough wiring knowledge or
experience, have your fan installed by a licensed
electrician.
For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check
mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should
you be interrupted.
Do not install or use fan if any part is damaged or missing. This product is designed to use only those parts
supplied with this product and/or any accessories designated specifically for use with this product by Fanimation.
Substitution of parts or accessories not designated for use with this product by Fanimation could result in
personal injury or property damage.
1. Check to see that you have received the following parts:
NOTE: If you are uncertain of part description, refer to exploded view illustration.
Hanger Bracket
Assembly (1)
Downrod/Hanger Ball
Assembly (1)
– Downrod (1)
– Hanger Ball (1)
– Set Screw (1)
– Hairpin Clip (1)
– Clevis Pin (1)
– Pin (1)
Hardware Bags
1/4˝ -20 Pan Head
Screws with lock washer (19)
3/16˝ -24
Serrated Head Screws (28)
One wire stripper
One lade
screwdriver
WARNING

Unpacking Instructions

Motor Coupling
Cover Assembly (1)
Canopy Screw
Cover Assembly (1)
Motor Assembly (1)
Wire Connectors (4)
#8-32 Junction Box Screws,
Stainless Steel and Flat Washers,
Stainless Steel (2)
iring outlet o and o connectors
re uired y the local code
conductor wire with ground of the following si e:
nstalled ire ength
p to ft
ft
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are
missing contact your local retailer.
Ceiling Canopy (1)
Light Kit Assembly (1)
Light Plate Assembly (1)
Bag Assembly Safety Cable
Safety Cable
(1)
4
Materials
ust e of type
he ini u wire would e a
ire i e
Blade Cover Set (1)
LED Assembly (1)
Blade Holder Set (1)
Steel Cap (1)
Hand-held Remote (1) Receiver (1)
Wall Holder (1) Wire Connectors (9)
Screws (2)
Batteries (2)
Cable Clamp Flat Washer,
(1) Stainless Steel
(1)
Lag Bolt Screw
(1)