Control Module Cover Removal
To gain access to the control wiring, and SD Card, first remove the control module cover as follows:
First remove the GKP by pulling from the top down,
and remove.
For Through Panel Mounting (Frames D-J
only) unscrew and remove mounting
brackets.
Control Module Removal
WARNING Isolate supply before plugging or unplugging control unit to the power stack.
2.
Lift lower edge of assembly.
Note that there are two
screws used to retain the
AC30D control module.
The communications
option, if fitted, should be
temporarily removed to
access one of the two
screws.
1.
Unscrew
captive screw.
Undo the screw and slide the control module
cover down slightly, then remove.
4.
Lift assembly away from Power Stack
English
3.
Slide assembly
upwards, as far
as possible, to
unlatch from unit.
1-5