Tools And Materials; Before You Begin - Kohler K-671 Guia De Instalacion

Tools and Materials

Adjustable
Hacksaw or
Wrench
Tubing Cutter
Solder
Sealant Tape

Before You Begin

CAUTION: Risk of product damage. Do not apply direct
heat to the valve body. Excessive heat will damage the rubber
valve seals and plaster guard. If desired, carefully remove the
internal valve components before soldering. Reassemble and
securely tighten the internal valve components.
Observe all local plumbing and building codes.
Carefully plan the installation before beginning. Carefully read
the entire instructions. Component location, spacing, and
situational requirements can vary.
Do not discard the plaster guard from the valve until instructed
to do so.
Shut off the main water supply.
Inspect the waste and supply tubing; replace if necessary.
Kohler Co. reserves the right to make revisions in the design of
products without notice, as specified in the Price Book.
1041157-2-B
Plus:
• 1/2"or 3/4" nominal
copper tubing & fittings.
Propane
Torch
2 Kohler Co.