Operation; 5�1 Cartridge Installation And Replacement; Select Mixing Program - Renfert Dynamix®speed 2 Manual De Instrucciones

5

Operation

5.1 Cartridge Installation and Replacement
A cartridge can only be installed or replaced if both pressure
discs (9, Fig� 1) are in their home position�
⇒ Close the unit cover (8, Fig� 1)�
⇒ Press the retract key (4)�
♦ The pressure discs return to their home position and automat-
ically stop�
Just before the end, the retraction speed reduces. Only open
the unit cover once the pressure discs have reached their
home position and have stopped.
If the return path of the pressing table is stopped by press-
ing the motion button, the table will not re-continue it's path
automatically. In order to continue it is necessary to press the
return path button again.
⇒ Open the unit cover (8, Fig� 1)�
⇒ Place cartridge (20) in unit attached� Please make sure that the
cartridge is fitted into place under the catch (12).
⇒ Select mixing program (15), cf� also section 5�1�1�
Information on the mixing program can be found on the cartridge
in the form of an „asterisk"
All impression materials which are not marked with these sym-
bols must be processed with the programme
⇒ Close the unit cover (8, Fig� 1)�
The cover will only close if the cartridge has been properly in-
stalled� The red "Unit cover open" LED (7, Fig� 1) will remain on
until the unit cover has been properly closed�
⇒ Please refer to the instructions of the casting material manufac-
turer when preparing and levelling the cartridge systems�
Use only mixing nozzles recommended by the material manufacturer. The use of other mixing
nozzles may cause malfunction.
5.1.1

Select mixing program

The mixing program is selected by pressing the program keys (15)�
The selection of a particular mixing program is confirmed by the
green LED lamp next to the relevant program key�
The mixing programs marked with an asterisk
only be used with special casting materials and cartridge/mixing
nozzle systems which carry these symbols�
Any casting materials and cartridge/mixing nozzle systems not car-
rying these symbols must be processed with the
Please note that casting materials which are processed with
the wrong mixing program will not meet the quality standards
guaranteed by the respective manufacturer.
The following points apply when selecting the mixing program:
Selecting the mixing program:
⇒ Activate the mixing program by pressing the corresponding program key (15, Fig� 7)�
♦ The LED next to the program key goes on�
For mixing program the following applies:
• When the extrusion process has been completed, the mixing program selected remains in standby
mode and is still enabled when the unit is switched off.
• When changing the cartridge, the pressure discs have been moved to their home position, the mixing
program is deactivated�
• As long as the pressure discs are in their home position, the unit cover is open and no mixing program
is activated, all program key LED are flashing.
or „diamond" symbol�
�
or diamond
mixing program�
- 7 -
4
12
may
15
en
Fig. 5
20
15
Fig. 6
Fig. 7