Dtmf Tx Hold; Automatic Dialer; Storing Adtmf Number In Memory - Kenwood TM-281A Manual De Instrucciones

DTMF TX H
OLD
This function causes the transceiver to remain in
transmission mode for 2 seconds after you release each
key. So, you can release Mic [PTT] while sending DTMF
tones.
1 Press [F], [MENU] and turn the Tuning control to
select Menu No. 30 (DT.H).
2 Press [MENU] and turn the Tuning control to select
"ON" or "OFF" (default).
3 Press [MENU] to store the setting or any other key to
cancel.
4 Press any key other than [MENU] to exit Menu Mode.

AUTOMATIC DIALER

If you use the 10 dedicated DTMF Memory Channels to
store DTMF numbers, you do not need to remember a
long string of digits.
S DTMF N
TORING A UMBER IN
1 Press [F], [MENU] and turn the Tuning control to
select Menu No. 28 (DTMF.MR).
2 Press [MENU] and turn the Tuning control to select
your desired DTMF Memory Channel number from 0
to 9.
• You can also select a DTMF Memory Channel by using
Mic [UP]/[DWN].
3 Press [MENU].
• The DTMF code entry display appears and the first digit
blinks.
4 Turn the Tuning control to select a DTMF code.
• You can also enter a DTMF code using the Mic keypad.
Simply press your desired DTMF codes on the keypad.
• On the display, is represented by "E" and
represented by "F".
5 Press [MR] to select the DTMF code and move the
cursor to the next digit.
• To move to the previous digit, press [VFO]. To delete the
character at the current cursor position, press [F].
M
EMORY
is
10
51