I Connecti Ng The Hose To The Wall FI Tti Ng; I Adjusti Ng The Hose Length - Polaris QUATTRO Instrucciones De Instalación

2.3 I Connecti ng the hose to the wall fi tti ng
• Disconnect the universal wall fi tti ng (UWF®) connector (
• Screw the universal wall fi tti ng (UWF®) connector (
onto the wall fi tti ng inlet, see step
• Insert the quick disconnect plug (
directi on, then pull outwards to lock in positi on, see step

2.4 I Adjusti ng the hose length

• With the end of the hose connected to the wall fi tti ng of the pool (
as the secti on of the pool located the furthest away. Do not include steps or seati ng areas.
- The end of the hose must be situated ±15 cm from the furthest part of the pool (
- If the hose is too short, add a feed hose secti on with fl oats, a swivel and two hose nuts, available from your retailer.
Adjust to the correct length.
• To avoid possible injury, use a suitable tool such as properly sized scissors and exercise care
when cutti ng the hose.
• Cut the hose so that it is ±15 cm from the part of the pool located the furthest from the wall fi tti ng (
Move the hose around the pool to determine the furthest part of the pool.
6
) from the quick disconnect plug (
) with the blue restrictor disc (the blue disc is already installed)
.
) into the universal wall fi tti ng (UWF®) connector (
.
), see step
) by rotati ng in the clockwise
), unwind the enti re length of hose (
).
Cut 15 cm from the
furthest secti on of the
pool
.
) as far
).