SUHNER LFB 44-DH Documentación Técnica página 4

Adaptor kit
10 Toolholder (ø 26 mm)
11 2 Screw
12 Wrench 5 mm
Recommended Accessories
13 Coupling with min. ID 4.5 mm/3/16"
14 1/2" Service Unit ( Capacity 5- 8 Micron).
Suitable Tools
General: If possible always mount shank in collet
until it bottoms out.
15 Burs
16 Mounted points, Attention always observe
mounting instructions.
Additional Abrasives and Tools can be found in
the the catalogs.
Air supply requirements
The DIN ISO quality specifications require, that air
is free of solid particles larger than 5 micron, re-
maining water content to be max. 6 g/m
dew point +3 degree C) and air may contain 5 mg/
3
m of oil. Therefore please observe the following:
• Operating with dirty and unlubricated air redu-
ces tool life substantially.
Before installing extension hoses, blow them
clean and minimize, if at all necessary cou-
pling and keep them clean.
• Conserve
Put some drops of oil in the air inlet and briefly
blow through.
Safety Instructions
• Do not exceed max. operating speed of tool
and clamping element.
• Observe accurate mounting of insert tools.
• Observe mounting instructions for Mounted
Stones!
• Run tool for a couple of seconds under no
load, replace vibrating insert tools at once,
Protect mounted points from knocks and gre-
ase.
• Secure work, use clamps or a vise to hold
work.
• The grinder operator shall wear safety gog-
gles or face shield at all times when the grin-
der is in operation.
• If noise level exceeds 85 dB(A) at the work
station, operator must use ear plug and/or ear
mufflers.
For additional safety instructions refer to enclosed
4
brochure DL 39 220 01.
Operation conditions and instructions
Ring throttle action
Turn ring throttle counter clock wise to open, turn
clock wise to close. Observe arrow direction.
Attention: Before connecting to air supply, check
that throttle is closed.
Clamping
Only clamp LFB 44 in toolholder 10, or other sup-
port with suitable bore, to prevent damage to be-
arings.
Grinding/Deburring/Cleaning
• Observe even material removal, avoid chatte-
ring.
• Do not treat any material containing asbestos.
Change of tools/abrasives
• Disconnect air supply before changing tools/
abrasives
3
(pressure • Hold Spindle 3 with wrench 4, mount or dis-
mount collet 5 using wrench 6.
• Check concentricity, use only vibration free
tools and always observe M.O.S. (Max. ope-
rating speed). Observe mounting instructions
for Mounted Stones!
Maintenance
• Store tool in a clean, dry place
Check the idling speed from time to time.
• Even if the tool still gives satisfactory service,
have it checked by a trained mechanic after
300 to 400 operation hours, or at least once a
year. Disassembly motor, clean and replace if
necessary the four vanes.
• Warranty claims can only be considered, if
tool is returned complete.
Accessories
All accessories can be found in the
sive Power Tool catalog.
Subject to change!
Abra-