Pump In Style Advanced Battery Pack; Battery Insertion - Medela pump in style advanced Instrucciones

Removing and securing the diaphragm cap:
Only remove diaphragm cap when cleaning is necessary. See
page 6 for detailed cleaning information.
To remove the diaphragm cap:
1. Turn off pump, and unplug from
2. Remove tubing (see instructions on
3. Snap off the diaphragm cap using
To secure the diaphragm cap:
Hold back of pump with one hand while pushing on the diaphragm
cap until it snaps into place.
connection
points
NOTE: The diaphragm cap must be completely snapped together at
all connection points (see arrows) to ensure adequate vacuum and
optimum pump performance.
14
power source.
page 11).
the thumb tab (see left photo).
Pump In Style Advanced Battery Pack
®
Instructions
The Pump In Style Advanced Battery Pack is
intended for use with the Pump In Style
Advanced breastpump (manufactured as of
January 2008 or later) ONLY. The battery
pack uses 8 AA alkaline batteries,
or, for more consistent pump performance,
use rechargeable batteries. Each set of bat-
teries will provide approximately 2 hours of
pumping time. It is recommended that bat-
teries be replaced or recharged between the
10th and 12th pumping session.

Battery Insertion

Slide off battery covers. Place the NEGATIVE (-)
end of the battery against the front of the spring.
Push the battery in and down in one motion until
the battery snaps into place. The POSITIVE (+)
end of the battery should be near the positive sign
on the battery pack. NOTE: If the battery is insert-
ed in the opposite direction, the battery may not
function correctly. Four batteries must be inserted
on each side of the pack. Replace battery covers.
15