Beninca DA.BA Libro De Instrucciones página 15

• When the YELLOW LED goes out, release the pushbutton. The program settings have been stored.
• Return the dip-switches to their original settings
3 -Programming type of slowdown
This allows to select how the barrier will slowdown after it trips the limit stop (both in open and close cycles).
The options are a constant slowdown (DEFAULT) or increasing, recommended in cases where the barrier in slowdown
is unable to fully close.
• With the motor off set the function dips as in the figure:
• Hold down the pushbutton next to the microprocessor; the YELLOW LED will stay on.
• When the YELLOW LED goes out, release the pushbutton. The program settings have been stored.
• Return the dip-switches to their original settings
4 - Programming the sba flashing mode when fully closed
This allows to select the operating mode of the Barrier Open Light (SBA) when the barrier is fully closed.
The options are: the SBA lights up every 3 sec. or it goes out (DEFAULT).
• With the motor off set the function dips as in the figure below:
• Hold down the pushbutton next to the microprocessor; the YELLOW LED will stay on.
• When the YELLOW LED goes out, release the pushbutton. The program settings have been stored.
• Return the dip-switches to their original settings
Positioning slowdown cams and limit stop
Shift the cams to calibrate the slowdown angle of the barrier during the open and close cycles.
When the barrier closes it may stop suddenly if the close slowdown cam only allows a very tight slowdown space.
To eliminate this problem shift the close slowdown cam to increase the slowdown space thereby allowing the barrier
to complete its cycle.
Adjust trimmers LIM-A and LIM-C until the current limiter trips both when the barrier is fully open and fully closed: when
the limiter trips in the open cycle green LED A goes out and in the close cycle red LED C goes out.
To obtain a constant slowdown (DEFAULT)
To obtain an increasing slowdown
To obtain SBA off (DEFAULT)
To obtain the SBA flashing
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
15