Publicidad
T-Connector Wiring Kit
INSTALLATION INSTRUCTIONS
1. Read instructions thoroughly before beginning.
2. Raise the vehicle hood, disconnect the vehicles negative
(-) battery cable and remove the battery hold down bracket. The
battery must be temporarily repositioned closer to the engine.
Note: Always refer to the vehicles owners manual for
information regarding battery
disconnection procedures.
3. Locate the gray electrical
connector between the battery
and the vehicle fender. Remove
the connector cap and connect
the small single wire T-Connector
harness end that mates with the vehicle connector
by firmly pressing
the two ends together (Fig. 1).
4. Route the fuse holder wire harness to the positive (+) side
of the vehicle battery. Attach the harness to the positive (+)
battery terminal.
5. Return the battery to its original position and secure the
harness and its connectors to the existing vehicle wiring with
cable ties (provided). Secure the battery with the hold down
bracket removed during step 2.
Caution: Do not reconnect the battery cable at this
time.
Note: Some models may have a 30 amp fuse holder
Fig. 1
Publicidad
