Descargar Imprimir esta página

Installation Instructions - Valley 30200 Instrucciones De Instalación

Publicidad

T-Connector Wiring Kit

INSTALLATION INSTRUCTIONS

1. Read instructions thoroughly
before beginning.
2. Open the rear liftgate and
remove both the left (drivers) and
right (passenger) tail light housing
assemblies by removing the two
bolts on each assembly and carefully
prying the housings outward, away
from the vehicle, being careful not to
break the alignment tabs (Fig. 1).
3. Disconnect the vehicle harness connector
from the left (driver's) side taillight socket, taking care not to
damage the locking tabs. Check the connector for dirt and
debris and clean if necessary.
4. Position the T-connector ends with the Yellow wires
between the vehicle harness connector and the taillight
assembly. Firmly press the connector ends together until the
locking tabs engage. Take care not to
damage the locking tabs.
5. Route the T-Connector harness
ends with the Green wires down
throught the opening between the
vehicle bumper and body (Fig. 2).
Fig. 1
Fig. 2

Publicidad

loading