Film Loading - Cosina CS-2 Folleto De Instrucciones

POWER SUPPLY
Your CS-2 is powered by two, 1.5 volt silver
oxide batteries (Eveready S-76, Mallory MS 76,
G 13 or equivalent).
Battery installation
1. Open the battery com partment by un-
screwing the battery compartment caver
(34) with a coin.
2. lnsert the batteries with the negative (-)
facing you. (Fig.1)
3. Replace the caver and tighten it firmi y.
Testing batteries
Test the batteries for sufficient power levels by
taking the following procedure:
1. Wind the advance lever (2) if previously not
wou nd.
2 . Turn the main switch lever (9) to "ON"
position.
3 . Depress the re lease button ( 17) slightly and
look into the viewfinder (24) . One of
sixteen LED dots for metering visible in the
viewfinder will il luminate if there is suf-
ficient power. (See Fig.5) If batteries are
below the operational voltage of the camera
system, replace them with a fresh set.
NOTE : Turn back the main switch lever to
"OFF" position when you ·are not taking
pictures.
Fig.1
FILM LOADING
Your CS-2 accepts 35mm, Black & White or
Color film standard cassettes.
To load the camera:
1. Press the release button to clear the camera
mechanism.
2. Fold out and lift up on the film rewind
crank (10) to open the camera back. (Fig.2)
3. lnsert the film cassette in the film chamber
(31), then push dawn the film rewind knob
(11) and tu rn it slig htly to lock the cassette
in place.
4. Pull film leader across the fi lm aperture (32)
and insert the end of leader into one of the
slots in the film take-up spool. (Fig .3)
6