Publicidad
Idiomas disponibles
Idiomas disponibles
- Position right heated grip
Catch
engages in driver
- Route cable in the accelerator position sensor without tension (as
shown).
- Position the cover.
Ensure that the cable can neither be kinked or pinched!
- Mount original screws
and tighten to 3.5 Nm.
- Mount left handlebar weight and tighten screw
- Position right handlebar weight with a spacing of
tighten screw
to 10 Nm.
NOTE
Observe spacing to prevent the throttle from getting stuck.
Cable routing
- Remove screws
.
- Pull the cover slightly forward.
- Route the cable of the heated grip on both sides along the existing
cables to the headlight mask.
- Join plug-in connector
of the two heated grips.
(included) on the handlebar.
.
to 10 Nm.
(2 mm) and
11
Publicidad
