Emerson CF610VNB00 Manual Del Usuario página 6

BP7495 CF610 Welland.qxp_ BP7495 3/10/15 4:21 PM Page 6
3.4
Mount the blade flange to the fan blade using three
#10-32 x 5/16" washer head screws (supplied)
(Figure 3).
Repeat this procedure for other four fan blades and
blade flanges.
To reduce the risk of personal injury, do not bend the
blade flange when installing the blade flanges,
balancing the blades or cleaning the fan. Do not insert
foreign objects in between rotating fan blades
3.5
Attach one blade assembly to the motor hub using two
1/4-20 x 1/2" round head screws with lockwashers in
flange. Make sure the screws are NOT tightened.
(Figure 4.)
Repeat this procedure for the other four blade
NOTE: The blade flanges have an interlocking assemblies.
feature that must be fully engaged before
tightening the screws. Make sure all the flanges are
properly engaged and then tighten the flange
screws. If one of the flanges does not seat properly
on the motor hub, loosen the adjacent flange
screws, re-engage and reseat the flanges, then
tighten the screws again.
3.6
Remove one of the three #8-32 x 5/16" round head
screws from the fan motor assembly (Figure 5). Retain
the screw for future installation.
Loosen the other two screws several turns.
Pass the fan motor assembly's black, blue and white
leads through the center hole of the switch housing
adapter.
Position the switch housing adapter on the motor
assembly and align the holes in the switch housing
NOTE: Do not pinch wires between the switch
adapter with the screws on the adapter.
housing assembly and the switch housing adapter.
Spare #8-32 x 5/16" round head screw is provided in
parts bag if needed.
3. Ceiling Fan Assembly
WARNING
!
(Continued)
#10-32 x 5/16" WASHER
HEAD SCREW (3)
BLADE FLANGE
Figure 3
Figure 4
Figure 5
6
FAN BLADE
1/4-20 x 1/2" ROUND HEAD
SCREW WITH LOCKWASHER
(2 per blade assembly)
BLADE/FLANGE
ASSEMBLY (5)
REMOVE ONE
#8-32 x 5/16" ROUND
HEAD SCREW
FAN MOTOR
ASSEMBLY
E.T.L. Model No.: CF610