Philips AVENT SCD501 Manual De Usuario página 11

Why does the parent unit beep?
• If the parent unit beeps while the 'link' light
flashes red continuously, the connection with
the baby unit is lost. Move the parent unit closer
to the baby unit or turn on the baby unit if it
was off. The baby unit may be turned off. Turn
on the baby unit.
Why does the appliance produce a high-pitched
noise?
• The units may be too close to each other.
Make sure the parent unit and the baby unit are
at least 1 meter/3.5 feet away from each other.
Why don't I hear a sound/Why can't I hear
my baby cry?
• The baby unit and the parent unit may be out
of range of each other. Reduce the distance
between the units.
• You may have set the volume to the lowest
level (mute). Increase the volume.
Why does the parent unit react too quickly to
other sounds?
• The baby unit also picks up other sounds than
those of your baby. Move the baby unit closer
to the baby (but observe the minimum distance
of 1 meter/3.5 feet).
The specified operating range of the baby
monitor is 300 meters/985 feet. Why does my
baby monitor manage a much smaller distance
than that?
• The specified range is only valid outdoors in
open air. Inside your house, the operating range
is limited by the number and type of walls and/
or ceilings in between. Inside the house, the
operating range is up to 50 meters/150 feet.
Why is the connection lost or are there sound
interruptions every now and then?
• The baby unit and the parent unit are probably
close to the outer limits of the operating
range. Try a different location or decrease the
distance between the units. Please note that
it takes about 30 seconds each time before a
connection between the units is established.
• You may have placed the unit next to a
transmitter or other DECT appliance, such as
a DECT telephone or other 1.8GHz/1.9GHz
baby monitor. Move the unit away from the
other appliances until the connection is re-
established.
Is my baby monitor secure from eavesdropping
and interference?
• The DECT technology of this baby monitor
guarantees no interference from other
equipment and no eavesdropping.
Why do the batteries of the parent unit run low
so fast when I use the unit on batteries?
• The operating time on batteries may be up
to 24 hours, but this depends on the type of
batteries and how often and how long you use
the parent unit on batteries. Please note that
the batteries are not charged when the parent
unit is connected to an electrical outlet.
Plug in the parent unit when an electrical outlet
is available close by to save battery power.
• Make sure you use 1.5V R6 AA alkaline
non-rechargeable batteries or charged
1.2V R6 AA rechargeable batteries.
Recharge the rechargeable batteries in a
separate battery charger.
Can I use the baby unit on batteries?
• No, you cannot use the baby unit on batteries.
The baby unit can only be used on electrical
power.
11