Moen MotionSense Guía Rápida página 4

Powering Up Your Faucet
Once batteries are inserted or AC power is supplied, the faucet will begin
startup mode. The blue LED indicator light on the Ready Sensor will blink,
water will run for several seconds, then the blue light will blink again.
Do not stand directly in front of faucet during startup/calibration.
Adjusting Hands-Free Temperature
When you use your faucet in the hands-free mode, simply
use the handle to adjust to your desired temperature mix.
Sensor Deactivation
4
Watch MotionSense deliver convenience on command.
Download the app at getscanlife.com.
Scan here for a video demo.
To Disable Both Sensors
Turn water on with handle. Hold hands directly over both
sensors for ten (10) seconds. The Ready Sensor light will
flash once after five (5) seconds. Continue holding hands
over both sensors until the Ready Sensor light flashes
twice. Both sensors are now deactivated. Turn handle off.
To Enable Both Sensors
Turn water on with handle. Hold hands directly over both
sensors for ten (10) seconds. The Ready Sensor light will
flash twice, signaling the sensors have been enabled.
Turn handle off.
To Disable the Ready Sensor
Turn water on with handle. Hold hands directly over both
sensors for five (5) seconds. The Ready Sensor light will
flash once, signaling that the Ready Sensor is disabled.
Turn handle off.
To Enable the Ready Sensor
Turn water on with handle. Hold hands directly over both
sensors for five (5) seconds. The Ready Sensor light will
flash once, signaling that the Ready Sensor is enabled.
Turn handle off.