Inspecting The Pressed Connection; Maintenance Instructions; Cleaning And Lubrication; Required Maintenance At Ridgid Authorized Service Center - RIDGID RP 340 Manual De Instrucciones

Pressure Release
Button
Figure 10 – Pressure Release Button

Inspecting The Pressed Connection

1. Inspect the pressed fitting. If the fitting is supplied with
a control ring and/or a control label by the fitting
man ufacturer, remove it. Control rings and label are
supplied by the manufacturer to indicate that the fitting
has not yet been pressed.
Look for the following:
• Excessive misalignment of the tubes. Note that a
slight amount of misalignment at the pressed con-
nection is considered normal.
• Tubes that are not fully inserted into the fitting –
dou ble check the insertion marks made on the
tube to see that they are still aligned with the end of
the fitting.
• Incorrect jaw or ring alignment with the fitting con-
tour, distorted or deformed fitting.
• Any other issues per the fitting manufacturer.
If any of these problems are found, then removal of
the fitting is required and a new fitting and tube will
need to be prepared and pressed in its place.
2. Test system in accordance with normal practice and
local codes.

Maintenance Instructions

WARNING
Make sure AC Battery Adapter is unplugged and
removed or battery is removed from tool before
performing maintenance or making any adjustment.

Cleaning and Lubrication

1. Daily wipe the tool clean with a clean dry cloth.
2. Inspect the attachment mounting pin and lubricate the
pin with silicone lubricant as needed.
RP 340 Press Tool
3. Check return springs in attachments with each use.
Attachments should open and close freely with only
moderate finger effort required.
Required Maintenance at RIDGID
Authorized Service Center
After 40,000 cycles, the tool will show a blinking yellow
LED on the display panel as long as the tool is turned on
to indicate that it is time for maintenance and recalibration.
The tool will not run if it is not maintained within 2,000
more cycles after the yellow blinking LED begins.

Accessories

WARNING
The following tool accessories have been de signed
to function with the RP 340 Press Tools. Other
accessories suitable for use with other tools may
become hazardous when used on the RP 340. To
prevent serious injury, use only the accessories
specifically designed and recommended for use
with the RP 340, such as those listed below.
Ridge Tool Company provides Standard Pressing
attachments designed specifically for use with
RIDGID Standard Press tools. Only use attachments
that are specifically designed to press the fitting
system you are installing. For a complete listing of
RIDGID attachments available for this tool, see the
Ridge Tool Catalog on line at www.RIDGID.com or
call Ridge Tool Technical Service Department (800)
519-3456.
RP 340 Press Tool Accessories
Catalog
No. Voltage Product Region
44823 120V China AC Power Adapter
43338 220V Europe AC Power (Mains) Adapter
44468 120V North America AC Power Adapter
27933 — Carrying Case (Plastic)
Battery Packs
Catalog
No. Capacity Region
44693 18V 2.0 Ah North & Latin America, Australia
44698 18V 4.0 Ah North & Latin America, Australia
43323 18V 2.0 Ah Europe & China
43328 18V 4.0 Ah Europe & China
31013 18V 1.1 Ah North & Latin America, Australia
32743 18V 2.2 Ah North & Latin America, Australia
31018 18V 3.3 Ah North & Latin America, Australia
32473 18V 1.1 Ah Europe & China
28218 18V 2.2 Ah Europe & China
28448 18V 3.3 Ah Europe & China
All listed batteries will work with any model RBC 20 charger. The difference
between batteries for different regions is in label markings.
Plug
Type
A
C
A
—
9