Xerox 4xxx LPS Host Machine Enablement
1.
Stop any job that is currently running and take the system offline.
2.
Log in at the log4 level. Type log 4 and press Enter.
3.
Type Field Engineer and press Enter.
Type edit and press Enter.
4.
The prompt, EDIT> displays.
5.
Type INS 10,10 and press Enter.
A line number will display, for example, 000010.
Type CLEAR = OUT135,0,0,0,0,0,0,0,0,0,0,0; and press Enter.
6.
The next line number will display, for example, 000020.
Type GBCPUNCH = OUT135,0,0,0,0,0,0,7,0,0,0,0; and press
7.
Enter twice. The EDIT> prompt displays again.
8.
Type SCE and press Enter.
The system will prompt you to name the file so it can save it.
Type FCG.LIB and press Enter.
9.
10. If the system asks you to overwrite the file, press Y for yes.
The system will save the GBC Punch Profile to the printer.
You must now load the profile. Use the following procedure to load
the profile.
1.
Press Enter to exit the EDIT> mode.
Type FCG GBCPUNCH and press Enter.
2.
NOTE: There is a space between FCG and GBCPUNCH.
The system will display a message indicating that the profile has
successfully loaded. This completes the profile setup.
Instruct the customer to send all punch jobs to Stacker bin E.
3.
This will route all punch jobs to the bypass transport and finisher with
the correct timing and profile values.
Personality Profiles
A
A-27