The New Queue Setup Window will display, as shown in Figure 1-18.
Queue
Name
3
Go to the Queue Name field and enter the name of the queue to be set
up, as follows:
GBCPunch
n
GBCSE
n
For any other finishing device, enter the name as it appears in its
n
Finisher Profile sheet.
4
Go to the Extended Options field and select Output, as shown in
Figure 1-18.
The Output Window will display, as shown in the information that
follows. This information consists of Print Queue Setup procedures for
the following finishing devices:
GBC Punch Queue Output (for the FusionPunch II)
n
GBC Short Edge Punch Queue Output (for the FusionPunch II and
n
Xerox High Capacity Stacker)
SBM1/SBM2 Queue Output (for the Signature Booklet Maker)
n
1-26
Figure 1-18: The New Queue Setup Window
Extended
Options
Fields
Output
Getting Started