Publicidad
Idiomas disponibles
Idiomas disponibles
This vehicle may be equipped with a "Factory Installed" hood switch harness. This har-
ness will be secured to the factory harness located near the hood switch mounting location
at the front of the passenger side fender. If this harness is present, Refer to step "a" in
the "Hood Switch Harness Installation" section below and connect the hood pin switch as
described, then proceed to "Remote Start Antenna Installation" and continue with this
instruction manual. If this vehicle DOES NOT have a factory installed hood switch har-
ness (one is supplied in the kit), complete the entire "Hood Switch Harness Installation"
procedure.
Factory Harness
Location
Hood Switch Harness Installation
1. Routing of the hood switch harness.
a. Route the hood switch harness up through the mount-
ing bracket, located on the driver's side fender.
b. Connect the hood switch to the harness and insert into
the mounting bracket until properly seated.
c. Using a 10mm socket, remove the factory grounding
lug located on the driver's side fender, near the battery.
d. Install the hood switch harness ground terminal over
the bolt and reinstall back into the fender.
Ground Location
6 of 11
Publicidad
