Craftmade Saratoga SAR52CH Guia De Instalacion página 6

6. Fan Assembly. (cont.)
Locate canopy cover in hardware pack. Slide yoke
cover, arm assembly, decorative downrod collar,
canopy cover and canopy over downrod. (NOTE:
Arm assembly must be turned with band toward
the motor housing; canopy cover must be turned
with shiny side toward the motor housing.) [Refer to
diagram 3.]
Thread safety cable and wires through hanging ball
and then slide hanging ball over downrod--the top
of the downrod should be noted as having a set
screw hole; use this hole when setting the set screw.
Insert stop pin into top of downrod and raise
hanging ball. Be sure stop pin aligns with slots on
the inside of the hanging ball. Tighten set screw
securely. [Refer to diagram 4.]
WARNING: Failure to tighten set screw (on hanging
ball) completely could result in the fan becoming
loose and possibly falling.
With the hanging bracket secured to the outlet box
and able to support the fan, you are now ready to
hang your fan. Grab the fan firmly with two hands.
Slide downrod through opening in hanging bracket
and let hanging ball rest on the hanging bracket.
Turn the hanging ball slot until it lines up with the
hanging bracket tab. [Refer to diagram 5.]
WARNING: Failure to align slot in hanging ball with
tab in hanging bracket may result in serious injury
or death.
Tip: Seek the help of another person to hold the
stepladder in place and to help lift the fan up to you
once you are set on the ladder.
Find a secure attachment point (wood ceiling joist
highly recommended) and secure safety cable. It
will be necessary to use a heavy duty wood screw,
washer and lock washer (not supplied) to secure
safety cable loop. [Refer to diagram 5.] If necessary,
adjust the loop at the end of the safety cable. The
loop at the end of the safety cable should just fit
over the threads on the wood screw. Test safety
cable by pulling on loose end with pliers. If the safety
cable slips, the loop must be adjusted smaller.
Extra cable slack can be left in ceiling area.
NOTE: The important safety precautions and
instructions appearing in the manual are not meant to
cover all possible conditions and situations that may
occur. It must be understood that common sense and
caution are necessary factors in the installation and
operation of this fan.
downrod
canopy cover
yoke cover
diagram 3
stop pin
diagram 4
wood
ceiling
joist
diagram 5
page 5
canopy
decorative
downrod collar
arm assembly
motor
housing
set screw hole
hanging ball
safety cable loop
wood screw
and washer
safety cable
hanging bracket tab
hanging ball slot
motor housing