Automated Learning Process./Activating Code; Remote Control Operation; Testing Your Fan - Craftmade Saratoga SAR52CH Guia De Instalacion

13. Automated Learning Process./Activating Code.

CAUTION: The wall and/or handheld remote control can be programmed
to multiple receivers or fans. If this is not desired, turn wall switch off to any
other programmable receiver or fan.
Restore electrical power and then, if using wall control, set slider switch
on wall control to the ON position. Within 60 seconds of turning on the
wall control, press and hold the fan OFF button on the wall control for
5 seconds or until light blinks twice.
Turn power off again for at least 5 seconds and then turn power back
on. Within 60 seconds of restoring the power, press and hold the fan
OFF button on the handheld remote control for 5 seconds or until light
blinks twice.
Test the light and fan functions to confirm the programming (learning
process) is complete--see Section 15 below.

14. Remote Control Operation.

ON/OFF slider switch - turns wall control ON or OFF
HIGH button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
OFF button - turns fan OFF
L1 button - turns lighted housing ON/OFF when pressed once;
dims lighted housing when pressed and held down
L2 button - turns light kit ON/OFF when pressed once;
dims light kit when pressed and held down
REV button - used to REVERSE blade direction
(fan must be set on low before reversing blade
direction)

15. Testing Your Fan.

It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light switch (if
applicable). Test wall control (optional installation) by locating
ON/OFF slider switch on wall control, then set to the ON
position. Test light and dimmer function and then test fan
speeds. Next, locate handheld remote control. Test the light
ON/OFF function by pressing the L1 button; repeat with the
L2 button. Test the dimmer function by pressing the L1 button
and holding it down for 1 second; repeat with the L2 button.
Test fan speeds with the different fan speed buttons. If the wall
and/or handheld remote control operates all of the functions of
the fan, battery has been installed correctly. If the wall and/or
handheld remote control do (does) not operate all of the
fan/light functions, refer to "Troubleshooting" section to solve
any issues before contacting Customer Service.
Fan must be on LOW before setting the fan to reverse direction.
Use "reverse" button to recirculate air depending on the season.
NOTE: If the wall control/handheld remote control interferes
with other appliances, turn off power and go back to the
instructions in Section 13 above.
(switch not functional on handheld remote)
wall control
page 10
-
1 1
-
2 2
handheld
remote control