Installation Preparation; Flushmount Installation; Hanging Bracket Installation - Craftmade Saratoga SAR52CH Guia De Instalacion

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3. Installation Preparation.

To prevent personal injury and damage, ensure
that the hanging location allows the blades a
clearance of 7ft. (2.13m) from the floor and 30in.
(76cm) from any wall or obstruction.
This fan is suitable for room sizes up to 400 square
feet (37.2 square meters).
This fan can be mounted with a downrod
on a regular (no-slope) or vaulted ceiling. The
hanging length can be extended by purchasing a
longer downrod (0.5in./1.27cm diameter). Other
installation, such as flushmount, is not available
for this fan.
Installation requires these tools:
Phillips screwdriver, flathead screwdriver,
adjustable pliers or wrench, stepladder, wire
cutters, and rated electrical tape.

4. Hanging Bracket Installation

Turn off circuit breakers to current fixture from breaker panel and
be sure operating light switch is turned to the OFF position.
WARNING: Failure to disconnect power supply prior to installation
may result in serious injury.
Remove existing fixture.
WARNING: To reduce the risk of fire, electric shock, or personal injury,
mount to outlet box marked "Acceptable for Fan Support of 22.68 kg
(50lbs) or Less" and use mounting screws provided with the outlet
box. Most outlet boxes commonly used for the support of lighting
fixtures are not acceptable for fan support and may need to be
replaced. Consult a qualified electrician if in doubt. When using an
existing outlet box, be sure the outlet box is securely attached to the
building structure and can support the full weight of the fan. Ensure
outlet box is clearly marked "Suitable for Fan Support." If not, it must
be replaced with an approved outlet box. Failure to do so can result in
serious injury.
CAUTION: Be sure outlet box is properly grounded and that a ground
(GREEN or bare) wire is present.
Install hanging bracket to outlet box, using original screws, spring
washers and flat washers provided with new or original outlet
box.* If installing on a vaulted ceiling, face opening of hanging
bracket towards high point of ceiling. Arrange electrical wiring
around the back of the hanging bracket and away from the
bracket opening.
*Note: It is very important that you use the proper hardware when
installing the hanging bracket as this will support the fan.
blade edge
30
inches
7 feet
(76cm)
(2.13m)
downrod
installation
hanging bracket
flat washers
spring washers
outlet box screws
page 3
12ft. - 20ft.
(3.66m - 6.1m)
flushmount
installation
Vaulted ceiling
angle is not to
exceed 25 degrees.

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido