Wiring - Craftmade Saratoga SAR52CH Guia De Instalacion

7. Wiring.

WARNING: Turn off circuit breakers to current fixture from
breaker panel and be sure switch is turned to the OFF
position.
CAUTION: Be sure outlet box is properly grounded and that a
ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with Local Codes or
Ordinances and the National Electrical Code. If you are
unfamiliar with electrical wiring or if the house/building wires
are different colors than those referred to in the diagram to the
right, please use a qualified electrician.
Note: Excess lead wire length from the fan can be cut to the
desired length and then stripped.
When downrod is secured in place on the hanging bracket,
WIRE THE RECEIVER with wire connectors provided AS
SHOWN IN DIAGRAM AT RIGHT.
Tip: While you are wiring, keep in mind that wires must not
obstruct receiver from sliding into hanging bracket.
* Wrap each wire connector separately with electrical tape as
an extra safety measure.
Gently insert receiver (flat side up) into hanging bracket and
carefully push wires and taped wire connectors into outlet
box. Let antenna rest outside of hanging bracket.
[PLEASE NOTE: Wall and/or handheld remote control
must be used for fan to operate. If you do not wish to
use the wall control, please proceed to Section 8 to
continue with fan installation.]
To install wall control, remove existing wall switch.
Wire one of the wall controls with wire connectors
provided as shown in diagram at right.
*Wrap each wire connector separately with electrical
tape as an extra safety measure. Gently push wires
and taped wire connectors into outlet box.
Install one 12-volt battery (included) in wall control.
IMPORTANT: Wall control will not function unless
battery is installed.
Since this fan comes with incandescent bulbs, the
dimmer switch (labeled DIM and ON) has been
pre-set to the "ON" position (DIM). If you do not wish
to have dimming capability, please move the switch
to the "OFF" position (ON).
Select a faceplate (almond or white) and press firmly
onto front of wall control. Attach wall control to outlet
box and secure with screws from original wall switch.
Attach wall plate (included) to wall control using 2
screws provided with the wall control.
white supply wire
black supply wire
blue
orange
white
black
from fan
from receiver
black
white
orange
blue
(wiring for receiver)
Modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
outlet box
green/ green/
green/
bare bare bare
ground ground
ground
black (OUT to fan)
black
black
(TO POWER supply)
black
(AC IN from
breaker box)
12V battery
(wiring for wall control)
page 6
from ceiling
from receiver
AC IN N
receiver
antenna
wall control
-
1 1
-
2 2
green
DIM ON
ground (green
or bare)
black
black
AC IN L
white
radio
radio or television
dimmer
switch
face-
plate