Maclaren quest Manual Del Usuario página 12

Instructions
IMPORTANT:
READ THESE INSTRUCTIONS CAREFULLY BEFORE USE AND KEEP THEM FOR FUTURE REFERENCE.
YOUR CHILDREN'S SAFETY MAY BE AFFECTED IF YOU DO NOT FOLLOW THESE INSTRUCTIONS.
1 TO OPEN THE BUGGY
buggy.
C Using foot, push the brake pedal down fully to engage
the primary locks.
CAUTION: Ensure that all locking devices are engaged
before use.
2 TO OPERATE BRAKES
Locate the brake lever at the back of the buggy frame.
A
side of the pedal.
side of the pedal.
CAUTION: Parking device shall be engaged during the
loading and unloading of children.
CAUTION: Ensure parking device is engaged before leaving
the buggy unattended.
3 TO OPERATE FRONT WHEEL SWIVEL LOCKS
A
on locking levers.
4 SEAT BELT/SHOULDER HARNESS OPERATION
WARNING:
AVOID SERIOUS INJURY FROM
FALLING OR SLIDING OUT.
ALWAYS USE SEAT BELT
A Pull shoulder straps over the childs shoulder then attach
to the waist clips by sliding strap loops onto the hooks.
are secured once the clips are fastened.
harness should be snug.
clasp simultaneously to release.
5 TO ADJUST SEAT RECLINE
A
seat locks and slide the seat back to desired position.
Lower hand grips to engage locks on both sides.
back to original upright or desired intermediate
position.
6 TO OPERATE THE LEGREST
openings. Locate sliders and pull forward
process to retract legrest.
7 TO FIT THE SHOPPING BAG
CAUTION: Overloading may cause a hazardous unstable
condition to exist. Maximum load 4.4 lb (2 kg) evenly
distributed.
The buggy may be folded with the bag still attached but all
contents must be removed. Failure to do this could
damage buggy and contents of shopping bag.
8 TO ATTACH THE HOOD
9 TO FIT THE RAIN APRON
10 REMOVING AND REFITTING THE SEAT COVER
11 TO REMOVE THE CARRY STRAP
12 TO FOLD THE BUGGY
buggy push seat
A
of bag at front.
C Attach rear straps to rear legs just above horizontal tie bar.
CAUTION: Overloading may cause a hazardous unstable
condition to exist. Maximum carrying capacity of hood
pouch - 1.1lb (0.5kg.)
A
the retainers located on the handle tubes.
C Extend hood and press down on side hinges to
lock open.
A Place the apron over the hood front.
C Attach the two eyelets (one each
Remove hood from buggy if fitted.
C Unclip seat cover retaining straps.
Unfasten seat fabric from handle tubes and seat base.
E
tubes into fabric slits.
G
over legrest strap and pass crotch strap buckle through
both holes in seat fabric and then hole in seat base.
feed through seat fabric and then through holes in seat
back arms.
Using foot, push the brake pedal down fully to engage
the primary lock.
Ensure the seat back is in its fullest upright position and the
hood(if fitted) is folded back. Remove contents of shopping
bag. It is recommended that the harness is fastened before
folding the buggy.
A Using foot, lift up on brake pedal to release primar lock.
C Grip handles and push forward on buggy.
buggy and engage storage clip.
en
back.
through holes.