Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION OF WORKING TOOLS
Remove working tool if already installed.
Use hexagonal key to unscrew the fixing screw (6), remove washer and remove the working tool.
Place working tool in the tool holder, make sure to close latch joint of the tool and tool holder.
You can place working tools onto the tool holder in any latching position (fig. B) to allow for operation
most comfortable and safe for the user.
Working tool should be installed with bend pointing down.
Place washer and tighten the screw (6) to install working tool.
Check that the tool is installed properly. Improperly or inaccurately installed working tools can slip
during operation and cause risk for the user.
DUST EXTRACTION
Dust of some materials may be hazardous to health, like paint coatings with lead additives, some
types of wood e.g. oak or beech or materials with asbestos. Therefore, we recommend use of external
dust extraction systems, good workplace ventilation and use of dust-mask with particle filter.
The tool is equipped with dust extraction add-on, which should be connected to external dust extractor
after installation, e.g. vacuum cleaner designed for the type of produced dust.
Remove working tool if already installed.
Install dust extraction add-on (5) and fix with clamp (4).
Connect suction hose, e.g. vacuum cleaner to the adaptor (3) of the dust extraction add-on (5).
Install working tool in the tool holder.
SWITCHING ON / SWITCHING OFF
The mains voltage must match the voltage on the label of the tool.
Switching on – slide the switch (2) forward to position I (fig. C).
Switching off – slide the switch (2) backward to position O.
Do not cover holes for motor ventilation in the tool body.
PRINCIPLES OF OPERATION
Oscillation frequency 20 000 rpm at 2.8° angle allows to work precisely in small areas and corners with the
power tool.
SAWING AND CUTTING
Use only undamaged working tools in good technical condition.
When sawing or cutting wood, fibre board, wood-based materials etc. make sure they do not contain
foreign objects like nails, bolts etc before starting the task. Remove foreign objects or use proper
blade for removal. You can make plunge cuts only in soft materials like wood, gypsum boards and
alike.
Cutting ceramic tiles causes faster wear of working tool.
SANDING
Working efficiency in surface sanding depends mainly on type and quality of sanding paper and pressure
applied for processing. Overpressure does not make sanding more efficient, it only causes faster wear of
sanding paper and may cause overheating of the power tool. Apply moderate and uniform pressure.
You can use tip or edge of the sanding pad to sand corners or edges in hardly accessible places.
Proceed with sanding tasks only with dust extraction system connected. Do not use paper previously
used for metal polishing for processing material of other type.
OPERATION / SETTINGS
13
Publicidad
