Cebora WF5 Manual De Istrucciones página 22

5 MAINTENANCE
5.1 Periodic inspection, cleaning
Periodically make sure that the welding system
equipment and all connections are in proper
condition to ensure operator safety.
Periodically open the panels of the wire feeder to
check the internal parts.
EN
Check the condition of the internal connections
and the electronic board connectors; in case of
"slow" connections, tighten or replace the
connectors.
Remove any dirt or metal dust from the wire liner
and gear motor unit, using a jet of low-pressure
dry compressed air or a brush.
Make sure that the mechanical parts of the roller
unit are not worn to the point where they need to
be replaced.
3301059/A
After making a repair, arrange the wiring in such a
way that the parts connected to the power supply
are safely insulated from the parts connected to
the welding circuit.
Do not allow wires to come into contact with
moving parts or parts that heat up during
operation.
Install the clamps as on the original machine to
prevent a connection from occurring between the
power supply and welding circuits if a conductor
accidentally breaks or becomes disconnected.
5.2 Scheduling
To program or update the wire feeder firmware,
refer to the welding power source user manual.
22