Valve Adapter Selection; Rt1000 Assembly Flow Chart - RIDGID RT1000 Manual De Instrucciones

RT1000 Tapping Tool
Valve Bore CTS
Size Size Adapter
3/4" 0.625 83317
0.688
1" 0.750
0.813
83322
0.875
0.938
SELECT
VALVE
ADAPTER
COMMERCIAL
SMALL
HOLE SAWS
76267 TO
76277 SMALL
HSS CUTTERS
76292 (5/8") &
76297 (7/8")
CARB. DRILLS
76317 TO 76327
SMALL PVC
CUTTERS
Tapping Tool is required. The following procedure
should be followed to assemble this tool:
1. Select the correct valve adapter, pilot drill, exten-
sion, and saw adapter from the Valve Adapter Chart
(Chart 1). The Flow Chart (Chart 2) will assist in de-
termining the required equipment to perform the tap.
2. Extend the tool by turning the sleeve counter-clock-
wise.
3. Inspect the o-ring seal in the valve adapter and re-
place if necessary.
4. Holding the bronze feed screw by the flats, hand-as-
semble the valve adapter onto the bronze feed screw.
Operator will feel first the seal engaging and then feel
the adapter reach an abrupt stop as the bronze feed
screw "bottoms out" in the valve adapter (Figure 1).
Collapse the tool by turning the sleeve clockwise.

Valve Adapter Selection

NPT NPT BSPT
Female Male Female
Adapter Adapter Adapter
83332 83337 84437
83342 83347 84447

RT1000 Assembly Flow Chart

76037
SMALL HOLE
SAW ADAPTER
Ridge Tool Company
BSPT M#110 Pilot
Male Female Size
Adapter Adapter
84432 83327 0.250
84442 83572 0.250
76027
SMALL
PILOT DRILL
Figure 1 – Assembling Valve Adapter Onto Feed Screw
Saw Remarks
Adapter
Preferred Configuration
0.250
76037
Preferred Configuration
FOR RT1000
MACHINE
SET-UP
5