Tabla De Contenido; Fig - Coolaroo 457020 Manual De Instrucciones

B. Using the set screw and nut screw tighten the bracket and clip
into place. (Fig. 9)
C. Use a 3/16" drill bit to pre-drill the holes. The optional wall
anchors, which can be inserted into the pre-drilled holes are
included if you are mounting the shade on a material other than
wood. Mount the bracket above or near the top of the roller
shade.
D. Clip the solar panel into place making sure the power cord in
on the right hand side. (Fig. 10)
E. Using the solar panel bracket/clip adjust the panel to the
desired position to receive the most sunlight. (Fig. 11)
F. Run the solar panel power cord along the top of the shade and
connect the solar panel to the motor. (Fig. 12)
NOTE: Your motorized roller shade may require
up to 48 hours of direct sunlight to charge the
battery. Please make sure to follow the solar panel
installation steps carefully to ensure your roller shade
is charging before you test the product.
5
HOW TO TAKE YOUR MOTORIZED ROLLER SHADE OUT
OF SLEEP MODE
A. Press the setting button on the right hand side of your roller
shade. Your roller shade will begin to move to the bottom
position. (Fig. 13)
B. Once your shade has stopped in the bottom position your
shade is ready for use.
NOTE: Make sure to only press the setting button once.
6
SET THIRD POSITION
Your shade has already been programed with top and bottom
positions. To set a third position specific to your window frame
please complete the following steps.
A. Place the shade in the desired position by hitting the down
arrow on your remote. Once the shade is at the desired
position, press the middle (stop) bottom on your remote.
(Fig. 14)
B. Remove the back of your remote. Press and hold the P2 button
until the roller shade walks (moves up and down) and beeps
once. (Fig. 15)
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13