Publicidad
9
ADJUST LIGHT BAR AND TIGHTEN SCREWS.
Adjust light bar to preferred angle then tighten
light bar hardware according to the manufacturer's
instructions. Test your install and retighten if necessary.
Ensure all screws are regularly checked and tightened
to ensure minimal bounce and maximum safety.
Ensure all wiring is retained according to the light bar
manufacturer instructions.
1
CENTER BRACKET ASSEMBLIES AND ADJUST SLOT/SPRING NUTS.
or crossbar by referring to Step 8 for light bar installation. Ensure there is an equal distance from the
Platform corners or crossbar ends as shown. Adjust slot/spring nuts in the channel so that they align with
the openings in bracket bases. The Torx wrench can be used to assist nut movement within the channel.
NOTE: The example orientation shown is of the bases down with arms
bottom mounted. This is suitable for mounting spot lights.
Instruction #28-13-336 Rev.3 - Page 6 of 13
Publicidad
