Publicidad
4
MOUNT SPOT LIGHTS TO BRACKET ASSEMBLIES.
Mount spot lights to the two bracket assemblies using the nuts supplied with your spot
Adjust the spot lights to your preferred angle then tighten the spot light hardware
according to the manufacturer's instructions. Test your install and retighten if necessary.
NOTE: M10/12 spot light hardware
is shown in this example.
NOTE:
in your spot light kit.
Ensure all nuts are regularly checked and tightened to
ensure maximum safety. Ensure all wiring is retained
according to Spot Light manufacturer instructions.
NOTE: Ensure that position and arrangement of spot lights complies
with relevant state legislation. Installation is now complete.
Instruction #28-13-336 Rev.3 - Page 8 of 13
Publicidad
