RDM RUST-OLEUM Cabinet Transformations Manual Del Usuario página 7

D. Clean the fronts, backs and sides of all doors as well as the fronts and backs of all
drawers. Begin by wetting one of the cleaning sponges included in your kit. Wearing
gloves, apply a generous amount of Wood Cleaner to the damp cleaning sponge.
Always follow the grain of the wood and avoid scrubbing in a circular motion.
E. After applying the Wood Cleaner wipe down the surface with the other cleaning
sponge and clean water to remove the residue left by the Wood Cleaner.
Rinse frequently.
F. Next, wipe with a dry rag or towel to complete the cleaning process. Continue on to
the back of the door and repeat the same process. Repeat process on cabinet frames
as well.
IMPORTANT:
vinyl or paper product. If so do not apply the Wood Cleaner. Be sure to tape off
these areas.
Allow doors and drawer frames to dry a minimum of 1 hour before applying
1
the Color Enhancer.
HOUR
Make Minor Repairs:
Inspect doors, drawers and cabinet frames for areas that may need repair. This includes
heavily worn areas, small dents, holes and areas missing stain color.
Missing Color: To hide small bare areas, use a stain marker to cover these areas.
Choose a color slightly lighter than the wood stain for best results. Simply draw
over the area and use a rag to wipe off excess.
Small Holes: If you are installing new door and drawer pulls, confirm that the new hardware
matches the existing holes. If not, fill any holes that aren't needed with stainable wood filler.
Let dry and sand flush to surrounding area. The Color Enhancer in the next step should
conceal this area. If not, use additional applications of Color Enhancer until the spot is
concealed.
Your side panels of cabinets may be covered with a wood grain
6