Silca Air4 Traducción De Las Instrucciones Originales página 8

Air4 Universal Receiver
Further copies can be made using either the Master or Slave remote control. The Master remote
control comes together with the Air4 Universal Receiver, whereas Slave remote controls are the ope-
ra onal ones copied later.
IMPORTANT: if you have a Silca AIR4 V remote control (with so ware version equal to or above 1.6)
with other automa on bu ons memorized on it and you make a copy of the Air4 Universal Receiver
code on the same remote control, the memorised automa ons will be deleted and will have to be
re-entered.
Note: We recommend memorising the receiver fi rst, and then the automa ons.
Rese ng Air4 Universal Receiver
Note: All the remote control bu ons in the universal receiver will be deleted.
Simultaneously press and hold down bu ons 'P' and 'S' for approximately 10 seconds un l LEDs 'L1'
and 'L2' start fl ashing rapidly; release the bu ons and wait a few seconds un l the LEDs go out. Air4
Universal Receiver has now been reset.
Dele ng a remote control bu on on the Air4 Universal Receiver
• Press bu on 'P' on the Air4 Universal Receiver for a few seconds un l LED 'L1' illuminates and fl ashes
rapidly; release the bu on.
• Press bu on 'S' for a few seconds un l LED 'L2' illuminates (both LED 'L1' and 'L2' illuminated) and
then release the bu on.
• Hold down the remote control bu on you wish to delete.
• Wait for LEDs 'L1' and 'L2' to go out.
Technical details of the Air4 Universal Receiver relay outputs
The Air4 Universal Receiver outputs can be programmed in four modes, confi gurable at any me. The-
se modes can be useful, for example, for controlling courtesy lights on vehicle entrances/pedestrian
paths.
• ON/OFF mode, bistable output
Output is closed when the remote control is pressed and is opened when it is next pressed. Output
status is maintained un l the remote control or any associated remote control is pressed again. A
power failure will take the output to its standby status, i.e. open.
• Impulsive mode (by default the outputs are set in this mode)
When the associated remote control bu on is pressed the output relay remains ac ve un l the remo-
te control bu on is released.
• Seconds mer mode
A me in seconds can be set, a er which the output is deac vated. Unless set otherwise, the basic
se ng for the mer is 30 seconds. The mer is recharged every me a remote control associated to
the output is pressed.
• Minutes mer mode.
A me in minutes can be set, a er which the output is deac vated.
Copyright Silca S.p.A 2019. All right reserved
E n g l i s h
8