I Starti Ng The Cleaning Cycle - Polaris W 430 Manual De Instalación Y De Uso

2.5 I Starti ng the cleaning cycle

To prevent all risks of injury or equipment damage, comply with the following directi ves:
• Bathing is prohibited when the appliance is in the pool.
• Do not use the appliance during shock chlorinati on.
• Do not leave the appliance unatt ended for an extended period.
• Do not use the appliance if the roller shutt er is closed.
• When the control box is powered up, the following symbols light up to indicate:
- The acti on in progress
- The cleaning cycle selected (depending on the model)
- that maintenance is required
• The control box switches to standby aft er 10 minutes and the screen is switched off . Press any key to exit standby
mode. Standby mode does not stop the appliance if it is in a cleaning cycle.
2.5.1 Selecti ng the cleaning cycle (depending on the model)
• A cleaning cycle is already confi gured by default: the symbols are lit.
• The cleaning cycle can be selected at any ti me, before the appliance starts or while it is operati ng. The new cycle will
start immediately.
• The cleaner adapts its movement strategy depending on the choice in order to opti mise coverage.
2.5.2 Launching the cleaning cycle
• Press
Tip to improve cleaning performance
At the start of the bathing season, launch several cleaning cycles in fl oor only mode (aft er removing the large
debris with a net).
Regular use of the cleaner (without exceeding 3 cycles per week) means that your pool will always be clean
and the fi lter less clogged.
2.5.3 Adjusti ng the cleaning ti me (depending on model)
• You may reduce or increase the cleaning ti me at any ti me (+/- 0.5 H).
• Press the butt on:
11
Surface to be cleaned
Floor only
Floor + walls + waterline
- 0.5 H
Normal
Durée
+ 0.5 H
normale
durati on